OberonPlace.com Forums

OberonPlace.com Forums (http://forum.oberonplace.com/index.php)
-   CorelDRAW/Corel DESIGNER VBA (http://forum.oberonplace.com/forumdisplay.php?f=16)
-   -   Bending shapes to match a curve (http://forum.oberonplace.com/showthread.php?t=1204)

jemmyell 01-11-2005 23:54

Bending shapes to match a curve
 
Hello,

Is it possible to bend a shape that has at least one straight side so that it matches a curve (think S curve) that is part of a drawing? Could this be offset from the defining curve by a specified distance? What would be a good approach for this? If the shape being bent has embedded shapes (group) I would like them to rotate to match the defing curve also. Think parallel lines with arrowheads at regular distances within the two parallel lines and the defining curve being an edge.

Thanks in advance for any possible ideas.

-James Leonard


All times are GMT -5. The time now is 06:24.

Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Copyright © 2011, Oberonplace.com