View Single Post
  #5  
Old 11-07-2010, 13:10
cncrouter
Guest
 
Posts: n/a
Smile

John - Thanks for providing the macro!

Visually, it works great

However, to see the path and direction the cutter will take, double-click to reveal the nodes, then tab though the nodes.

The path to the inside contours is not via the connection line added by the macro. Instead, the cutter still "hops" across the gap.

It looks like some intelligent re-ordering of the lines & nodes are needed so that the inside contour is cut, then exits via the connection line, and continues to cut the outside contour.

Is this possible? If so, this would be a great solution!

Ed
Reply With Quote