View Single Post
  #7  
Old 13-07-2010, 11:23
cncrouter
Guest
 
Posts: n/a
Default

Hi John - That's pretty close! I'm amazed at what you've done in a short macro.

It works well on simple objects (see attached cdr).

The top object with straight lines works great.

The middle drawing was a combination of two closed polygons (this is how it appears after I trace the bitmap original). The node sequence jumps from one to the other where I have the red arrows.

For the bottom drawing, I broke apart the two closed polygons, performed an inside contour on each, and ran the macro on each one individually. This works except for the area in the red circle.

I test the node (cutting) sequence by double-clicking to show the nodes, then tab through them to visualize how the cutter will travel.

Ed
Attached Files
File Type: cdr macrotest4.cdr (29.6 KB, 577 views)
Reply With Quote