View Single Post
  #12  
Old 13-07-2010, 18:48
runflacruiser's Avatar
runflacruiser runflacruiser is offline
Senior Member
 
Join Date: Jun 2009
Location: Pigeon Forge, TN USA
Posts: 811
Default

Quote:
Originally Posted by cncrouter View Post
John - On the bottom drawing, one of the nodes in the red circle jumps to a node on the upper left of the drawing.

However, after breaking the curves apart and running your nodeOrder macro, it works perfectly.

I'll perform more testing and if all works well I'll integrate this into my artwork preparation workflow for cutting.

Thanks again!

Ed
You can combine the entire thing and run nodeOrder. It should fix the entire curve.
You could also integrate the nodeOrder sub into the first sub.

-John
Reply With Quote